модуль реле 12 Вольт с опторазвязкой

Maximum operating current: 60mA

Trigger mode: low level trigger, high level trigger

Load voltage: 30V DC or 250V AC

Load the most flow: 10A

Relay life: more than 100,000 times

Maximum switching frequency: less than or equal to 5KHz

Trigger voltage range

12V low level trigger module: 0-5VDC relay ON (ON), 6-12VDC relay disconnect (OFF)

12V high-level trigger module: 6-12VDC relay ON (ON), 0-5.5VDC relay disconnect (OFF)

Module description:
1. the module uses genuine quality relay, normally open interfaces Maximum load: AC 250V/10A, DC 30V/10A;
2. using SMD optocoupler isolation, driving ability, stable performance; trigger current 5mA;
3. the module Operating voltage 12V ;
4. the module can be high or low by a jumper setting trigger;
5. fault-tolerant design, even if the control line is broken, the relay will not operate;
6. the power indicator (green), the relay status indicator (red)
7. the interface design of human nature, all interfaces are available through a direct connection terminal leads, very convenient
8. module size: 50mm*26mm*18.5mm (L*W*H)

Module interface:
1. DC+: positive power supply (VCC)
2. DC-: negative power supply (GND)
3. IN: can be high or low level control relay

Relay outputs:
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally closed relay interface

High and low level trigger options:
It is low level trigger when jumper connect to LOW pin
It is high level trigger when jumper connect to HIGH pin